Home › ENGINE › 2GR-FE COOLING › COOLING FAN RELAY

COOLING FAN RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. COOLING FAN RELAY


    A035654
  1. Remove the relay from engine room relay block No. 1.

  1. Measure the resistance of the relay.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    3 - 5
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

    If the result is not as specified, replace the cooling fan relay.

  1. Install the relay to engine room relay block No. 1.