DTC C0278/11 Open in ABS Solenoid Relay Circuit |
DTC C0279/12 Short to B+ in ABS Solenoid Relay Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| C0278/11 | The solenoid relay contact is OFF for 0.2 seconds or more when the solenoid relay is turned ON. |
|
| C0279/12 | The solenoid relay contact is ON for 0.2 seconds or more when the solenoid relay is OFF. |
|
| 1.INSPECT FUSE (ABS 2 FUSE) |
Remove the ABS 2 fuse from the FL block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| ABS 2 (30 A) fuse | Below 1 Ω (Continuity) |
|
| ||||
| OK | |
| 2.INSPECT SKID CONTROL ECU (+BS TERMINAL VOLTAGE) |
![]() |
Install the ABS 2 fuse.
Disconnect the skid control ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S3-2 (+BS) - Body ground | Always | 10 to 14 V |
|
| ||||
| OK | |
| 3.INSPECT SKID CONTROL ECU (GND TERMINAL CONTINUITY) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| S3-1 (GND1) - Body ground | Below 1 Ω |
| S3-23 (GND2) - Body ground | Below 1 Ω |
|
| ||||
| OK | |
| 4.RECONFIRM DTC |
Clear the DTCs (Click here).
Start the engine.
Drive the vehicle at the speed of 6 km/h (4 mph) or more.
Check that the same DTCs are recorded (Click here).
| Condition | Proceed to |
| DTCs (C0278/11 and C0279/12) are output | A |
| DTCs (C0278/11 and C0279/12) are not output | B |
|
| ||||
| A | ||
| ||