Home › BODY › SLIDING ROOF › SLIDING ROOF SWITCH ASSEMBLY

SLIDING ROOF SWITCH ASSEMBLY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT SLIDING ROOF SWITCH ASSEMBLY


    B068442E04
  1. Remove the switch.

  1. Check the resistance between the terminals when operating the switch.

    Resistance:
    Terminals No.
    Switch Operation
    Specified Condition
    6 ←→ 5
    TILT UP is pressed
    Below 1 Ω
    2 ←→ 5
    SLIDE OPEN is pressed
    2, 6 ←→ 5
    OFF
    10 kΩ or higher

    If the result is not as specified, replace the switch set.