Home › ENGINE › 2GR-FE STARTING › STARTER

STARTER > DISASSEMBLY

for Preparation Click here



1. REMOVE REPAIR SERVICE STARTER KIT


    A079718
  1. Remove the nut and disconnect the lead wire from the repair service starter kit.



    A079719
  1. Remove the 2 screws which are used to secure the repair service starter kit to the repair service starter kit.

  1. Remove the repair service starter kit.

  1. Remove the return spring and the plunger from the repair service starter kit.



2. REMOVE STARTER YOKE ASSEMBLY


    A079720
  1. Remove the 2 through bolts and pull out the starter yoke together with the starter commutator end frame.



    A079721
  1. Remove the starter yoke from the starter commutator end frame.



3. REMOVE STARTER ARMATURE PLATE


    A079722
  1. Remove the starter armature plate from the starter yoke.



4. REMOVE DRIVE HOUSING STARTER BEARING COVER


    A079723
  1. Using a screwdriver, remove the drive housing starter bearing cover.



5. REMOVE STARTER ARMATURE ASSEMBLY


    A082440E03
  1. Using snap ring pliers, remove the snap ring and plate washer.

  1. Remove the starter armature from the commutator end frame.



6. REMOVE PLANETARY GEAR


    A081167
  1. Remove the 3 planetary gears from the repair service starter kit.