STARTER > REASSEMBLY |
| 1. INSTALL PLANETARY GEAR |
![]() |
Apply grease to the planetary gears and pin parts of the planetary shaft.
Install the 3 planetary gears.
| 2. INSTALL STARTER ARMATURE ASSEMBLY |
![]() |
Apply grease to the plate washer and the armature shaft.
Install the starter armature to the starter commutator end frame.
Using snap ring pliers, install the plate washer and a new snap ring.
![]() |
Using a vernier caliper, measure length of the snap ring.
| 3. INSTALL DRIVE HOUSING STARTER BEARING COVER |
![]() |
Install the drive housing starter bearing cover to the starter commutator end frame.
| 4. INSTALL STARTER ARMATURE PLATE |
![]() |
Insert the starter armature plate to the starter yoke.
Align the keyway of the starter plate with the key inside the starter yoke, and install the starter plate.
| 5. INSTALL STARTER COMMUTATOR END FRAME ASSEMBLY |
![]() |
Align the rubber with the convex cutout of starter yoke.
Install starter commutator end frame to the starter yoke.
| 6. INSTALL STARTER YOKE ASSEMBLY |
![]() |
Align the key of the starter yoke with the keyway of repair service starter kit.
![]() |
Install the starter yoke with the 2 through bolts.
| 7. INSTALL REPAIR SERVICE STARTER KIT |
![]() |
Apply grease to the plunger and the hook.
Hang the plunger hook of the repair service starter kit to the drive lever.
Install the plunger and return spring.
![]() |
Install the repair service starter kit with the 2 screws.
![]() |
Connect the lead wire to the repair service starter kit with the nut.