Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › DYNAMIC LASER CRUISE CONTROL SYSTEM

DYNAMIC LASER CRUISE CONTROL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedures to troubleshoot the dynamic laser cruise control system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS

      NEXT


      3.PROBLEM SYMPTOM CONFIRMATION

        Result:
        Condition
        Proceed to
        Symptom occurs
        A
        Symptom does not occur
        B



      A.
      GO TO STEP 4
      B

      SYMPTOM SIMULATION


      4.INSPECT BATTERY VOLTAGE

        Standard voltage:
        11 to 14 V
        If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.


      NEXT


      5.CHECK COMMUNICATION FUNCTION OF MULTIPLEX COMMUNICATION SYSTEM (BEAN)
      1. Use the Techstream to check if the multiplex communication system (MPX) is functioning normally.

        Result:
        Result
        Proceed to
        MPX DTC is not output
        A
        MPX DTC is output
        B



      B.
      PROCEED TO "MULTIPLEX COMMUNICATION SYSTEM"
      A


      6.CHECK COMMUNICATION FUNCTION OF CONTROLLER AREA NETWORK (CAN)
      1. Use the Techstream to check for normal function of the CAN communication system.

      2. Check for DTCs.

        Result:
        Condition
        Proceed to
        DTC is not output
        A
        DTC is output
        B



      B.
      PROCEED TO "CAN COMMUNICATION SYSTEM"
      A


      7.DTC CHECK

        Result:
        Condition
        Proceed to
        DTC is output
        A
        DTC is not output
        B



      B.
      GO TO STEP 9
      A


      8.DTC CHART

        NEXT

        GO TO STEP 10


        9.PROBLEM SYMPTOMS TABLE

          NEXT


          10.CIRCUIT INSPECTION

            NEXT


            11.TERMINALS OF ECM

              NEXT


              12.IDENTIFICATION OF PROBLEM

                NEXT


                13.REPAIR OR REPLACE

                  NEXT


                  14.CONFIRMATION TEST

                    NEXT

                    END