UNDERDRIVE CLUTCH > INSPECTION |
| 1. INSPECT UNDERDRIVE PACK CLEARANCE |
![]() |
Install the underdrive clutch to the transaxle case.
Install a dial indicator as shown in the illustration.
Measure the underdrive clutch pack clearance while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).
| Mark | Thickness | Mark | Thickness |
| 1 | 3.0 (0.118) | 4 | 3.6 (0.122) |
| 2 | 3.2 (0.126) | 5 | 3.8 (0.130) |
| 3 | 3.4 (0.134) | - | - |
| 2. INSPECT UNDERDRIVE CLUTCH DISC NO.1 |
![]() |
Check if the sliding surface of the disc, plate and flange are worn or burnt. If necessary, replace them.
| 3. INSPECT UNDERDRIVE CLUTCH DRUM SUB-ASSEMBLY |
![]() |
Using a dial indicator, measure the inside diameter of the underdrive clutch drum bushing.
| 4. INSPECT UNDERDRIVE CLUTCH RETURN SPRING SUB-ASSEMBLY |
![]() |
Using a vernier calipers, measure the free length of the spring together with the spring seat.