UNDERDRIVE CLUTCH > DISASSEMBLY |
| 1. INSPECT UNDERDRIVE PACK CLEARANCE |
| 2. REMOVE UNDERDRIVE CLUTCH FLANGE NO.2 HOLE SNAP RING |
![]() |
Using a screwdriver, remove the underdrive clutch flange No.2 snap ring.
| 3. REMOVE UNDERDRIVE CLUTCH DISC NO.1 |
![]() |
Remove the flange, 4 discs and 4 plates from the underdrive clutch drum.
| 4. REMOVE UNDERDRIVE CLUTCH RETURN SPRING SUB-ASSEMBLY |
![]() |
Place SST on the clutch balancer and compress the spring with a press.
Using a snap ring expander, remove the snap ring.
![]() |
Remove the clutch balancer from the underdrive clutch drum.
![]() |
Remove the return spring from the underdrive clutch drum.
| 5. REMOVE UNDERDRIVE CLUTCH PISTON SET |
![]() |
Install the underdrive clutch to the transaxle case.
Holding the underdrive clutch piston by hand, apply compressed air (392 kPa, 4.0 kgf/cm2, 57 psi) to the transaxle case to remove the underdrive clutch piston.
| 6. REMOVE UNDERDRIVE CLUTCH DRUM O-RING |
![]() |
Using a screwdriver, remove the O-ring from the underdrive clutch drum.