UNDERDRIVE CLUTCH > REASSEMBLY |
| 1. INSTALL UNDERDRIVE CLUTCH DRUM O-RING |
![]() |
Coat a new O-ring with ATF, and install it to the underdrive clutch drum.
| 2. INSTALL UNDERDRIVE CLUTCH PISTON SET |
![]() |
Coat the underdrive clutch piston with ATF, and install it to the underdrive clutch piston drum.
| 3. INSTALL UNDERDRIVE CLUTCH RETURN SPRING SUB-ASSEMBLY |
![]() |
Install the return spring to the underdrive clutch drum.
Coat the clutch balancer with ATF.
![]() |
Install the clutch balancer to the underdrive clutch drum.
![]() |
Place SST on the clutch balancer and compress the piston return spring with a press.
Using a snap ring expander, install the snap ring to the underdrive clutch drum.
Be sure that the end gap of the snap ring is not aligned with the spring retainer claw.
![]() |
Set the end gap of the snap ring in the underdrive clutch drum as shown in the illustration.
| 4. INSTALL UNDERDRIVE CLUTCH DISC NO.1 |
![]() |
Coat the 4 discs with ATF.
Install the 4 plates, 4 discs and flange to the underdrive clutch drum.
| 5. INSTALL 1ST & REVERSE BRAKE RETURN SPRING SHAFT SNAP RING |
![]() |
Using a screwdriver, install the underdrive clutch flange No.2 hole snap ring.
Check that the end gap of snap ring is not aligned with one of the cutouts.
| 6. INSPECT UNDERDRIVE PACK CLEARANCE |