Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › DYNAMIC LASER CRUISE CONTROL SYSTEM

DTC    P0500    Vehicle Speed Sensor Malfunction

DTC    P0503    Vehicle Speed Sensor "A" Intermittent / Erratic / High

for Preparation Click here


DESCRIPTION

The cruise control system uses the same vehicle speed signal that is sent to the ECM for the SFI system. If DTC P0500 is detected, perform the diagnosis using the inspection procedure for DTC P0500 in the SFI system . The speed signal is converted for use by the cruise control inside the ECM.
Both the SFI system and the cruise control system can set DTC P0500, however the detection conditions of the two systems are different.

DTC No.
DTC Detection Condition
Trouble Area
P0500
The vehicle speed signal from the vehicle speed sensor is cut for 0.14 seconds or more while cruise control is operating
  1. Vehicle speed sensor
  2. Vehicle speed sensor signal circuit
  3. ECM
P0503
Momentary interruption and noise are detected when a rapid change of vehicle speed occurs while cruise control is in operation
  1. Vehicle speed sensor
  2. Vehicle speed sensor signal circuit
  3. ECM

WIRING DIAGRAM

Refer to DTC P0500 .

INSPECTION PROCEDURE

Refer to DTC P0500 .