Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › DYNAMIC LASER CRUISE CONTROL SYSTEM

DTC    P1615    Communication Error from Distance Control ECU to ECM

DTC    U1101    Lost Communication with Distance Control ECU

for Preparation Click here


DESCRIPTION

The distance control ECU receives information about the area in front of the vehicle from the laser sensor and then sends a brake control demand signal (deceleration demand) and diagnosis signals, such as laser sensor grime signals or laser sensor malfunction signals, to the ECM.

DTC No.
DTC Detection Condition
Trouble Area
P1615
While the dynamic laser cruise control is either preparing for operation or operating, if communication data from the distance control ECU is logically inconsistent for a certain amount of time, the ECM records this logical error code
  1. Communication circuit
  2. Distance control ECU
  3. ECM
U1101
While the dynamic laser cruise control is either preparing for operation or operating, if communication data from the distance control ECU is invalid for a certain amount of time, the ECM records this communication cut off code
  1. Communication circuit
  2. Distance control ECU
  3. ECM

INSPECTION PROCEDURE

HINT:
This circuit uses CAN communication. Therefore, if there are any malfunctions in the communication circuit, one or more DTCs in the CAN communication system are output.

1.CHECK CAN COMMUNICATION SYSTEM
Refer to HOW TO PROCEED WITH TROUBLESHOOTING (Click here).

NEXT

END