DTC C1290/66 Steering Angle Sensor Zero Point Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1290/66 | The steering angle sensor zero point calibration position vastly differs from the recorded value |
|
| 1.PERFORM ZERO POINT CALIBRATION OF YAW RATE AND DECELERATION SENSOR |
Perform zero point calibration of the yaw rate and deceleration sensor (Click here).
| NEXT | |
| 2.CHECK STEERING ANGLE SENSOR ZERO POINT CALIBRATION |
Drive the vehicle straight ahead at 35 km/h (22 mph) or more for at least 5 seconds.
Check that the centered position of the steering wheel is correctly set while driving straight ahead.
|
| ||||
| OK | |
| 3.RECONFIRM DTC |
Turn the ignition switch off.
Clear the DTC (Click here).
Start the engine.
Drive the vehicle and turn the steering wheel to the right and left at the speed of 35 km/h (22 mph) or more.
Check if the same DTC is recorded (Click here).
| Result | Proceed to |
| DTC (C1290/66) is not output | A |
| DTC (C1290/66) is output | B |
|
| ||||
| A | ||
| ||