Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > TERMINALS OF ECU



CHECK INSTRUMENT PANEL J/B ASSEMBLY (MULTIPLEX NETWORK BODY ECU)


  1. Disconnect the B6, B7 and B9 ECU connectors.


    B067998E03

  2. Disconnect the 1A, 1C, 1L and 1K J/B connectors.

  3. Measure the voltage and resistance between each terminal of the wire harness side connectors and body ground.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    IG (1A-1) - Body ground
    W - Body ground
    Ignition power supply
    Always
    10 to 14 V
    ACC (1A-1) - Body ground
    W - Body ground
    Ignition power supply (ACC signal)
    Always
    10 to 14 V
    BECU (1C-24) - Body ground
    W-L - Body ground
    +B (BECU) power supply
    Always
    10 to 14 V
    ALTB (1C-30) - Body ground
    B - Body ground
    +B (power system, generator system power supply)
    Always
    10 to 14 V
    GND1 (1L-16) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    GND2 (1K-17) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    LCTY (1P-19) - Body ground
    GR - Body ground
    Rear LH courtesy switch
    Rear door LH CLOSED (OFF) → OPEN (ON)
    10 kΩ or higher → Below 1 Ω
    KSW (B6-21) - Body ground
    L-B - Body ground
    Key unlock warning switch input
    No key in ignition key cylinder (OFF) → Key inserted (ON)
    10 kΩ or higher → Below 1 Ω
    PCTY (B7-23) - Body ground
    R-Y - Body ground
    Passenger side courtesy switch
    Passenger side door CLOSED (OFF) → OPEN (ON)
    10 kΩ or higher → Below 1 Ω
    BCTY (B7-25) - Body ground
    G-W - Body ground
    Back door courtesy switch
    Back door CLOSED (OFF) → OPEN (ON)
    10 kΩ or higher → Below 1 Ω
    DCTY (B9-14) - Body ground
    R-Y - Body ground
    Driver side courtesy switch
    Driver side door CLOSED (OFF) → OPEN (ON)
    10 kΩ or higher → Below 1 Ω
    RCTY (B9-16) - Body ground
    R-W - Body ground
    Rear RH courtesy switch
    Rear door RH CLOSED (OFF) → OPEN (ON)
    10 kΩ or higher → Below 1 Ω
    HCTY (B8-10) - Body ground
    R-W - Body ground
    Engine hood courtesy switch
    Engine hood CLOSED (OFF) → OPEN (ON)
    10 kΩ or higher → Below 1 Ω
    If the result is not as specified, there may be a malfunction on the wire harness side.

  4. Reconnect the B6, B7 and B9 ECU connectors.

  5. Reconnect the 1A, 1C, 1L and 1K J/B connectors.

  6. Measure the voltage between each terminal of the connectors and the body ground.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    HORN (1C-25) - Body ground
    G-B - Body ground
    Vehicle horn drive
    Vehicle horn is sounding
    (Theft deterrent system is in alarm sounding state)
    Pulse generation
    (0 V ← → 12 V)
    HAZ (B6-2) - Body ground
    G-O - Body ground
    Hazard warning light drive
    Answer-back OFF → Answer-back ON
    Below 1 V → Pulse generation
    IND (B6-24)* - Body ground
    B - Body ground
    Security indicator output
    Security indicator lights up (It lights up only for 30 sec. in alarm sounding state.
    It flashes when immobiliser system is operating.)
    3 to 6 V
    SH (B8-1) - Body ground
    GR - Body ground
    Security horn drive
    Security horn is sounding
    (Theft deterrent system is in alarm sounding state)
    Pulse generation
    (0 V ← → 12 V)
    *: with Engine Immobiliser System
    If the result is not as specified, the J/B assembly (body ECU) may have a malfunction.