Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > CUSTOMIZE PARAMETERS


HINT:
The following items can be customized.

NOTICE:
  1. After confirming whether the items requested by the customer are applicable or not for customization, perform customizing operations.
  2. Be sure to record the current settings before customization.
  3. When troubleshooting, make sure that the item in question is not set to "OFF" as a result of customization (Example: For the system, "the wireless function does not operate", first check that the wireless function is not set to "OFF", then perform troubleshooting).


CUSTOMIZE
  1. Connect Techstream to the DLC3.

  2. Turn the ignition switch to the ON position.

  3. Turn the tester on.

  4. Enter the following menus:
    Select: Customize Setting

  5. Select the setting by referring to the table below.


Security 
DISPLAY (Item)
DEFAULT
CONTENTS
SETTING
Passive Mode
OFF
  1. PASSIVE MODE is a function that switches theft deterrent system from arming preparation state to armed state 30 seconds after key is removed from ignition key cylinder and driver side door is closed, even if doors are not locked by wireless or door key lock operation
  2. In PASSIVE MODE, if you do not perform following operations within 14 seconds after door is opened during armed state, theft deterrent system will judge that condition as a theft and switch to alarm sounding state
    1. Unlock any door by wireless operation
    2. Reconnect battery
    3. Insert key into ignition key cylinder and turn ignition switch from OFF to ON
    4. Unlock any door by key operation
ON/OFF
Warn by Horn
ON
Function that makes vehicle horn and theft deterrent horn be able to be used as a warning device
ON/OFF
Entry Delay
14 s
Function that changes entry delay time (time before warning starts) for PASSIVE MODE
0 s/14 s/30 s