Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › OCCUPANT CLASSIFICATION SYSTEM

OCCUPANT CLASSIFICATION SYSTEM > DTC CHECK / CLEAR

for Preparation Click here


HINT:
Use the Techstream to read and clear the DTC of the occupant classification ECU, otherwise the DTCs cannot be read and cleared.


DTC CHECK
  1. Turn the ignition switch to the LOCK position.

  2. Connect the Techstream to the DLC3.

  3. Turn the ignition switch to the ON position and turn the Techstream on.

  4. Enter the following menus: Body Electrical / Occupant Detection / Trouble Code.

  5. Check the DTCs by following the prompts on the Techstream screen.

    HINT:
    Refer to the Techstream operator's manual for further details.


DTC CLEAR
  1. Turn the ignition switch to the LOCK position.

  2. Connect the Techstream to the DLC3.

  3. Turn the ignition switch to the ON position and turn the Techstream on.

  4. Enter the following menus: Body Electrical / Occupant Detection / Trouble Code.

  5. Clear the DTCs by following the prompts on the Techstream screen.

    HINT:
    Refer to the Techstream operator's manual for further details.