SLIDING ROOF HOUSING > REMOVAL |
| 1. REMOVE ROOF HEADLINING ASSEMBLY |
| 2. REMOVE SLIDING ROOF SIDE GARNISH LH |
![]() |
Disengage the 3 claws.
Disengage the rear clip.
Disengage the front clip.
Remove the slide garnish by pulling it rearward.
| 3. REMOVE SLIDING ROOF SIDE GARNISH RH |
| 4. REMOVE SLIDING ROOF GLASS SUB-ASSEMBLY |
Using a T25 "TORX" socket wrench , remove the 4 screws and sliding roof glass sub-assembly.
| 5. REMOVE SLIDING ROOF HOUSING ASSEMBLY |
Disconnect the 4 hoses and drive gear wire harness connector.
Remove the 8 bolts and 4 brackets.
Remove the 6 nuts and housing.
| 6. REMOVE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY |
Remove the 2 bolts and drive gear.
| 7. REMOVE SUNSHADE TRIM SUB-ASSEMBLY |
| 8. REMOVE ROOF DRIP CHANNEL REAR |
| 9. REMOVE SLIDING ROOF DRIVE CABLE LH |
![]() |
Remove the 4 guide clips.
Using a screwdriver, separate the link rod from the link holder, as shown in the illustration.
![]() |
Using long nose pliers, level the part indicated in the illustration.
Pull out the deflector lifter link and drive cable together.
| 10. REMOVE SLIDING ROOF DRIVE CABLE RH |
| 11. REMOVE ROOF WIND DEFLECTOR PANEL SUB-ASSEMBLY |
![]() |
Using a screwdriver, disengage the claw of the panel, as shown in the illustration.
![]() |
Using a screwdriver, push hard the part indicated in the illustration to remove the panel.
| 12. REMOVE SLIDING ROOF HOUSING PANEL |
Remove the 2 screws and housing panel.
| 13. ADJUST FULLY CLOSE POSITION |
![]() |
Using a screwdriver, slide the drive cable of the sliding roof to align the matchmarks.