Home › BODY ELECTRICAL › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM

WIRELESS DOOR LOCK CONTROL SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST
  1. The wireless door lock control data list can be displayed while the Techstream is connected to the DLC3 with the ignition switch in the ON position. Follow the prompts on the tester screen to access the DATA LIST.

    BODY: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    IG SW
    Ignition switch signal / ON or OFF
    ON: Ignition switch ON or START
    OFF: Ignition switch OFF or ACC
    -
    Key Unlock Warning SW
    Unlock warning switch / ON or OFF
    ON: Ignition key is inserted
    OFF: Ignition key is not inserted
    -
    Wireless Control
    Wireless door lock control function / ON or OFF
    ON: Operates
    OFF: Does not operate
    -
    Hazard Answer Back
    Hazard answer-back of wireless / ON or OFF
    ON: Operates
    OFF: Does not operate
    -
    Open Door Warning
    Open door warning / ON or OFF
    ON: Operates
    OFF: Does not operate
    -
    Auto Lock Time
    Automatic lock time / 60 s or 30 s
    60 s: 60 seconds
    30 s: 30 seconds
    -
    Unlock 2 Operation
    2 times operation of wireless unlock / ON or OFF
    ON: All doors unlock when UNLOCK pressed twice
    OFF: All doors unlock when UNLOCK pressed once
    -
    Panic Function
    Panic function / ON or OFF
    ON: Operates
    OFF: Does not operate
    -
    Wireless Buzzer Resp
    Wireless door lock buzzer response / ON or OFF
    ON: Operates
    OFF: Does not operate
    -


ACTIVE TEST

HINT:
Performing the ACTIVE TEST using the Techstream allows components such as the relay, VSV and actuator to operate without removing parts. Performing the ACTIVE TEST as the first step in troubleshooting is one way to shorten labor time.
It is possible to display the DATA LIST during the ACTIVE TEST.

  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch to the ON position.

  3. According to the display on the tester, preform the ACTIVE TEST.

    HINT:
    The ignition switch must be turned to the ON position to proceed with the ACTIVE TEST using the Techstream.


    BODY: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Hazard
    Turn signal flasher relay
    ON / OFF
    -
    Wireless Buzzer
    Wireless door lock buzzer
    ON / OFF
    -
    Trunk and Back-Door Open
    Back door opener motor
    ON / OFF
    -