Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Parking Brake Switch Circuit

for Preparation Click here


DESCRIPTION

This circuit is from the parking brake switch to the navigation receiver assembly.

WIRING DIAGRAM


E111727E22


INSPECTION PROCEDURE

1.CHECK BRAKE WARNING LIGHT
  1. Check that the brake warning light comes on when the parking brake is applied and goes off when it is released.

    OK:
    The brake warning light operates as specified above.



OK
Go to step 3
NG


2.INSPECT PARKING BRAKE SWITCH


    E071372E01
  1. Disconnect the parking brake switch.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Condition
    Specified condition
    Switch connector - Switch body
    ON (When shaft is not pressed)
    Below 1 Ω
    Switch connector - Switch body
    OFF (When shaft is pressed)
    10 kΩ or higher



NG
REPLACE PARKING BRAKE SWITCH
OK


3.CHECK HARNESS AND CONNECTOR (PARKING BRAKE SWITCH - NAVIGATION RECEIVER ASSEMBLY)


    E120118E03
  1. Disconnect the navigation receiver assembly connector R12 and parking brake switch connector P6.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Condition
    Specified condition
    PKB - P6-1 (A/T)
    Always
    Below 1 Ω
    PKB - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE