Home › BODY ELECTRICAL › DOOR LOCK › KEY REMINDER WARNING SYSTEM

KEY REMINDER WARNING SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK DRIVER SIDE J/B ASSEMBLY (MULTIPLEX NETWORK BODY ECU)


  1. Disconnect the B6, 1C, 1K and 1L J/B connectors.


    B069836E01

  2. Measure the voltage and resistance according to the value(s) in the table below.

    Standard resistance:

    Symbols
    (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    BECU (1C-24) - Body ground
    W-L - Body ground
    +B (BECU) power supply
    Always
    10 to 14 V
    BECU (1L-7) - Body ground
    W-L - Body ground
    +B (BECU) power supply
    Always
    10 to 14 V
    GND1 (1L-16) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    GND2 (1K-17) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    KSW (B6-21) - Body ground
    L-B - Body ground
    Key unlock warning switch input
    No key in ignition key cylinder →
    Key inserted
    10 kΩ or higher →
    Below 1 Ω

    HINT:
    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the 1C, 1K, 1L and B6 connectors.

  4. Measure the voltage according to the value(s) in the table below.

    Standard voltage:

    Symbols
    (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    DCTY (B9-14) - Body ground
    R-Y - Body ground
    Driver door courtesy switch input
    Driver door
    CLOSED → OPEN
    10 to 14 → 0 V