Home › BODY › SEAT › FRONT POWER SEAT CONTROL SYSTEM

FRONT POWER SEAT CONTROL SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



DATA LIST

HINT:
Using the Techstream's Data List allows the status of a switch, sensor, actuator and other items to be read without removing any parts. Reading the Data List early in troubleshooting is one way to save time.

  1. Connect Techstream (with CAN VIM) to the DLC3.

  2. Turn the ignition switch on.

  3. Read the Data List.

    Driver Seat 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Reclining Rear
    Reclining switch signal (Rearward)/ ON or OFF
    ON: Reclining switch (Rearward) is ON
    OFF: Reclining switch (Rearward) is OFF
    -
    Reclining Front
    Reclining switch signal (Forward)/ ON or OFF
    ON: Reclining switch (Forward) is ON
    OFF: Reclining switch (Forward) is OFF
    -
    Front Vertical Down
    Front vertical switch signal (Downward)/ ON or OFF
    ON: Front vertical switch (Downward) is ON
    OFF: Front vertical switch (Downward) is OFF
    -
    Front vertical Up
    Front vertical switch signal (Upward)/ ON or OFF
    ON: Front vertical switch (Upward) is ON
    OFF: Front vertical switch (Upward) is OFF
    -
    Lifter Switch Down
    Lifter switch signal (Downward)/ ON or OFF
    ON: Lifter switch (Downward) is ON
    OFF: Lifter switch (Downward) is OFF
    -
    Lifter Switch Up
    Lifter switch signal (Upward)/ ON or OFF
    ON: Lifter switch (Upward) is ON
    OFF: Lifter switch (Upward) is OFF
    -
    Slide Rear
    Sliding switch signal (Rearward)/ ON or OFF
    ON: Sliding switch (Rearward) is ON
    OFF: Sliding switch (Rearward) is OFF
    -
    Slide Front
    Sliding switch signal (Forward)/ ON or OFF
    ON: Sliding switch (Forward) is ON
    OFF: Sliding switch (Forward) is OFF
    -
    Power Voltage
    Power supply for position control ECU and switch assembly/ MIN: 0 V, MAX: 19.89 V
    Within range from 11 to 14 V
    -
    Ignition Switch
    Ignition switch position/ ON or OFF
    ON: Ignition switch is ON
    OFF: Ignition switch is OFF
    -
    KSW Switch
    Key unlock warning switch signal/ ON or OFF
    ON: Key is in ignition key cylinder
    OFF: Key is not in ignition key cylinder
    -
    DCTY Switch
    Door courtesy light switch signal/ ON or OFF
    ON: Driver side door is open
    OFF: Driver side door is closed
    -
    P Switch
    Shift lever position P signal/ ON or OFF
    ON: Shift lever in P position
    OFF: Shift lever in any position except P
    -
    M2 Switch
    Seat memory M2 switch signal/ ON or OFF
    ON: Seat memory M2 switch is ON
    OFF: Seat memory M2 switch is OFF
    -
    M1 Switch
    Seat memory M1 switch signal/ ON or OFF
    ON: Seat memory M1 switch is ON
    OFF: Seat memory M1 switch is OFF
    -
    SET Switch
    Seat memory set switch signal/ ON or OFF
    ON: Seat memory set switch is ON
    OFF: Seat memory set switch is OFF
    -
    Slide Position
    Seat sliding position/ MIN: -4096, MAX: 4096
    Within range from -4096 to 4096
    -
    Reclining Position
    Seatback position/ MIN: -4096, MAX: 4096
    Within range from -4096 to 4096
    -
    Front Vertical Position
    Seat front vertical position/ MIN: -4096, MAX: 4096
    Within range from -4096 to 4096
    -
    Lifter Position
    Seat lifter position/ MIN: -4096, MAX: 4096
    Within range from -4096 to 4096
    -
    Memory No. 1
    Driving position memorized with seat memory switch M1/ MEM or NOT MEM
    MEM: Memorized
    NOT MEM: Not memorized
    -
    Memory No. 2
    Driving position memorized with seat memory switch M2/ MEM or NOT MEM
    MEM: Memorized
    NOT MEM: Not memorized
    -
    Seat Memory No. 1
    Seat position memorized with seat memory switch M1/ MEM or NOT MEM
    MEM: Memorized
    NOT MEM: Not memorized
    -
    Seat Memory No. 2
    Seat position memorized with seat memory switch M2/ MEM or NOT MEM
    MEM: Memorized
    NOT MEM: Not memorized
    -
    Driver Mirror Memory No. 1
    Driver side mirror position memorized with seat memory switch M1/ MEM or NOT MEM
    MEM: Memorized
    NOT MEM: Not memorized
    -
    Driver Mirror Memory No. 2
    Driver side mirror position memorized with seat memory switch M2/ MEM or NOT MEM
    MEM: Memorized
    NOT MEM: Not memorized
    -
    Passenger Mirror Memory No. 1
    Front passenger side mirror position memorized with seat memory switch M1/ MEM or NOT MEM
    MEM: Memorized
    NOT MEM: Not memorized
    -
    Passenger Mirror Memory No. 2
    Front passenger side mirror position memorized with seat memory switch M2/ MEM or NOT MEM
    MEM: Memorized
    NOT MEM: Not memorized
    -
    Slide Pos Mem No. 1
    Seat sliding position memorized with seat memory switch M1/ MIN: -4096, MAX: 4096
    Within range from -4096 to 4096
    -
    Reclining Pos Mem No. 1
    Seatback position memorized with seat memory switch M1/ MIN: -4096, MAX: 4096
    Within range from -4096 to 4096
    -
    Front Vrtcl Pos Mem No. 1
    Front vertical position memorized with seat memory switch M1/ MIN: -4096, MAX: 4096
    Within range from -4096 to 4096
    -
    Lifter Pos Mem No. 1
    Lifter position memorized with seat memory switch M1/ MIN: -4096, MAX: 4096
    Within range from -4096 to 4096
    -
    Slide Pos Mem No. 2
    Seat sliding position memorized with seat memory switch M2/ MIN: -4096, MAX: 4096
    Within range from -4096 to 4096
    -
    Reclining Pos Mem No. 1
    Seatback position memorized with seat memory switch M2/ MIN: -4096, MAX: 4096
    Within range from -4096 to 4096
    -
    Front Vrtcl Pos Mem No. 2
    Front vertical position memorized with seat memory switch M2/ MIN: -4096, MAX: 4096
    Within range from -4096 to 4096
    -
    Lifter Pos Mem No. 2
    Lifter position memorized with seat memory switch M2/ MIN: -4096, MAX: 4096
    Within range from -4096 to 4096
    -
    Otr(D) Mir Pos Mem No. 1
    Driver side mirror position memorized with seat memory switch M1/ MIN: 0, MAX: 65535
    Within range from 0 to 65535
    -
    Otr(P) Mir Pos Mem No. 1
    Front passenger side mirror position memorized with seat memory switch M1/ MIN: 0, MAX: 65535
    Within range from 0 to 65535
    -
    Otr(D) Mir Pos Mem No. 2
    Driver side mirror position memorized with seat memory switch M2/ MIN: 0, MAX: 65535
    Within range from 0 to 65535
    -
    Otr(P) Mir Pos Mem No. 2
    Front passenger side mirror position memorized with seat memory switch M2/ MIN: 0, MAX: 65535
    Within range from 0 to 65535
    -


ACTIVE TEST

HINT:
Using the Techstream's Active Test allows the relay, VSV, actuator, and other items to be operated without removing any parts. Reading the Active Test early in troubleshooting is one way to save time. The Data List can be displayed during the Active Test.

  1. Connect Techstream (with CAN VIM) to the DLC3.

  2. Turn the ignition switch on.

  3. Perform the Active Test by following the directions on the tester screen.

    Driver Seat 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Seat Reclining
    Test detail: reclining operation
    Vehicle condition: stopped
    FRONT/REAR
    -
    Front Vertical Operation
    Test detail: front vertical operation
    Vehicle condition: stopped
    UP/DOWN
    -
    Lifter Operation
    Test detail: lifter operation
    Vehicle condition: stopped
    UP/DOWN
    -
    Seat Slide Operation
    Test detail: sliding operation
    Vehicle condition: stopped
    FRONT/REAR
    -