Home › BODY › MIRROR › POWER MIRROR CONTROL SYSTEM (w/ Memory)

POWER MIRROR CONTROL SYSTEM (w/ Memory) > Power Source Circuit

for Preparation Click here


DESCRIPTION

This is the power source circuit for the outer mirror control ECU.

WIRING DIAGRAM


B111208E18


INSPECTION PROCEDURE

1.INSPECT OUTER MIRROR CONTROL ECU (POWER SOURCE)


    B126325E02
  1. Disconnect the O9 or O11 ECU connector.

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Outer mirror control ECU LH:
    Voltage:
    Tester Connection (Symbols)
    Condition
    Specified Condition
    O9-6 (BDR) - Body ground
    Always
    10 to 14 V
    O9-4 (CPUB) - Body ground
    Always
    10 to 14 V
    O9-3 (SIG) - Body ground
    Ignition switch ON
    10 to 14 V

    Resistance:
    Tester Connection (Symbols)
    Condition
    Specified Condition
    O9-1 (GND) - Body ground
    Always
    Below 1 Ω

    Outer mirror control ECU RH:
    Voltage:
    Tester Connection (Symbols)
    Condition
    Specified Condition
    O11-6 (BDR) - Body ground
    Always
    10 to 14 V
    O11-4 (CPUB) - Body ground
    Always
    10 to 14 V
    O11-3 (SIG) - Body ground
    Ignition switch ON
    10 to 14 V

    Resistance:
    Tester Connection (Symbols)
    Condition
    Specified Condition
    O11-1 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE WIRE HARNESS
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE