POWER MIRROR CONTROL SYSTEM (w/ Memory) > DIAGNOSIS SYSTEM |
| DESCRIPTION |
When troubleshooting a vehicle with the diagnosis system, the only difference from the usual troubleshooting procedure is connecting Techstream to the vehicle and reading various data output from the vehicle's clearance warning ECU.
The clearance warning ECU records DTCs when the computer detects a malfunction in the computer itself or in its circuits.
To check the DTCs, connect Techstream to the DLC3 on the vehicle. Techstream enables you to erase the DTCs, activate the various actuators, and check the freeze frame data and Data List.
| CHECK DLC3 |
![]() |
The ECU uses ISO 15765-4 for communication. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 15765-4 format.
If the result is not as specified, the DLC3 may have a malfunction. Repair or replace the harness or connector.
| Symbol (Terminal No.) | Terminal Description | Condition | Specified Condition |
| SIL (7) - SG (5) | Bus "+" line | During transmission | Pulse generation |
| CG (4) - Body ground | Chassis ground | Always | Below 1 Ω |
| SG (5) - Body ground | Signal ground | Always | Below 1 Ω |
| BAT (16) - Body ground | Battery positive | Always | 11 to 14 V |
| CANH (6) - CANL (14) | CAN bus line | Power switch OFF* | 54 to 69 Ω |
| CANH (6) - CG (4) | HIGH-level CAN bus line | Power switch OFF* | 200 Ω or higher |
| CANL (14) - CG (4) | LOW-level CAN bus line | Power switch OFF* | 200 Ω or higher |
| CANH (6) - BAT (16) | HIGH-level CAN bus line | Power switch OFF* | 6 kΩ or higher |
| CANL (14) - BAT (16) | LOW-level CAN bus line | Power switch OFF* | 6 kΩ or higher |