Home › COMMUNICATION SYSTEM › MULTIPLEX COMMUNICATION › MULTIPLEX COMMUNICATION SYSTEM

DTC    B1208    Passenger Side Outer Mirror ECU

for Preparation Click here


DESCRIPTION

  1. This DTC is detected when communication between the outer mirror control ECU RH and multiplex network gateway ECU stops for more than 10 seconds.

DTC No.
DTC Detecting Condition
Trouble Area
B1208
Passenger side outer mirror ECU communication stops
  1. Outer mirror control ECU RH
  2. Wire harness

WIRING DIAGRAM


C160422E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (OUTER MIRROR CONTROL ECU RH - BATTERY)


    C160415E01
  1. Disconnect the O11 ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Connection
    Specified Connection
    O11-3 (SIG) - Body ground
    Ignition switch: ON
    11 to 14 V
    O11-4 (CPUB) - Body ground
    Always
    11 to 14 V
    O11-6 (BDR) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (OUTER MIRROR CONTROL ECU RH - GROUND)


    C160415E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Connection
    Specified Connection
    O11-1 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK COMMUNICATION LINE


    C160702E01
  1. Disconnect the G4 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Connection
    Specified Connection
    O11-8 (MPX1) - G4-3 (MPD1)
    Always
    Below 1 Ω
    O11-8 (MPX1) - G4-12 (MPD2)
    Always
    Below 1 Ω

    Result:
    Result
    Proceed to
    Both are OK
    A
    One is OK
    B
    Both are NG
    C



B
REPAIR OR REPLACE HARNESS OR CONNECTOR AND OUTER MIRROR CONTROL ECU RH

C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

REPLACE OUTER MIRROR CONTROL ECU RH