Home › COMMUNICATION SYSTEM › MULTIPLEX COMMUNICATION › MULTIPLEX COMMUNICATION SYSTEM

DTC    B1209    Driver Side Outer Mirror

for Preparation Click here


DESCRIPTION

  1. This DTC is detected when communication between the outer mirror control ECU LH and multiplex network gateway ECU stops for more than 10 seconds.

DTC No.
DTC Detection Condition
Trouble Area
B1209
Driver side outer mirror ECU communication stops
  1. Outer mirror control ECU LH
  2. Wire harness

WIRING DIAGRAM


C160422E02


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (OUTER MIRROR CONTROL ECU LH - BATTERY)


    C160415E03
  1. Disconnect the O9 ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Connection
    Specified Connection
    O9-3 (SIG) - Body ground
    Ignition switch: ON
    11 to 14 V
    O9-4 (CPUB) - Body ground
    Always
    11 to 14 V
    O9-6 (BDR) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (OUTER MIRROR CONTROL ECU LH - GROUND)


    C160415E04
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Connection
    Specified Connection
    O9-1 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK COMMUNICATION LINE


    C160726E01
  1. Disconnect the G4 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Connection
    Specified Connection
    O9-8 (MPX1) - G4-3 (MPD1)
    Always
    Below 1 Ω
    O9-8 (MPX1) - G4-12 (MPD2)
    Always
    Below 1 Ω

    Result:
    Result
    Proceed to
    Both are OK
    A
    One is OK
    B
    Both are NG
    C



B
REPAIR OR REPLACE HARNESS OR CONNECTOR AND OUTER MIRROR CONTROL ECU LH

C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

REPLACE OUTER MIRROR CONTROL ECU LH