Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

DTC    B2780    Push Switch / Key Unlock Warning Switch Malfunction

for Preparation Click here


DESCRIPTION

This DTC will be output if the transponder key ECU does not detect that the unlock warning switch is on even when the ignition switch is on (Under the normal conditions, the unlock warning switch is on when the ignition switch is on).

DTC No.
DTC Detection Condition
Trouble Area
B2780
Unlock warning switch on is not detected when ignition switch is on
  1. Unlock warning switch assembly
  2. Wire harness
  3. Transponder key ECU assembly

WIRING DIAGRAM


B069243E01


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM
  1. Connect Techstream to the DLC3.

  1. Turn the ignition switch on.

  1. Turn the tester on.

  1. Enter the following menus: Body Electrical / Immobiliser / Data List.

  1. Read the Data List according to the display on the tester.

    Immobiliser: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    KEY SW
    Unlock warning switch signal /ON or OFF
    ON: Key is in ignition key cylinder
    OFF: No key is in ignition key cylinder
    -

    OK:
    ON (Key is in ignition key cylinder) appears on the screen



OK
REPLACE TRANSPONDER KEY ECU ASSEMBLY
NG


2.INSPECT UNLOCK WARNING SWITCH ASSEMBLY


    B111614E01
  1. Remove the unlock warning switch.

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Switch pushed (Key set)
    Below 1 Ω
    Switch free (Key removed)
    10 kΩ or higher



NG
REPLACE UNLOCK WARNING SWITCH ASSEMBLY
OK


3.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU ASSEMBLY - UNLOCK WARNING SW ASSEMBLY)


    B111594E04
  1. Disconnect the T6 ECU and K4 switch connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester Connection
    Specified Condition
    T6-10 (KSW) - K4-2
    Below 1 Ω
    T6-10 (KSW) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SW ASSEMBLY - BODY GROUND)


    B111599E01
  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester Connection
    Specified Condition
    K4-1 - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TRANSPONDER KEY ECU ASSEMBLY