Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

DTC    B2784    Antenna Coil Open / Short

for Preparation Click here


DESCRIPTION

The transponder key coil is built into the transponder key amplifier and receives a key code signal from the transponder chip in the key. This signal is amplified by the amplifier, and output to the transponder key ECU.

DTC No.
DTC Detection Condition
Trouble Area
B2784
Antenna coil open/short
  1. Transponder key amplifier
  2. Wire harness
  3. Transponder key ECU assembly

WIRING DIAGRAM


B111588E24


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM
  1. Connect Techstream to the DLC3.

  1. Turn the ignition switch on.

  1. Turn the tester on.

  1. Enter the following menus: Body Electrical / Immobiliser / Data List.

  1. Read the Data List according to the display on the tester.

    Immobiliser: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Antenna Coil Status
    Antenna coil condition /NORMAL or FAIL
    NORMAL: Antenna coil is normal.
    FAIL: Antenna coil is malfunctioning.
    -

    OK:
    NORMAL (Antenna coil is normal) appears on the screen.



OK
REPLACE TRANSPONDER KEY ECU ASSEMBLY
NG


2.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU ASSEMBLY - TRANSPONDER KEY AMPLIFIER)


    B111591E05
  1. Disconnect the T6 ECU and I14 switch connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester Connection
    Specified Condition
    T6-8 (VC5) - I14-1 (VC5)
    Below 1 Ω
    T6-11 (CODE) - I14-4 (CODE)
    T6-12 (TXCT) - I14-5 (TXCT)
    T6-13 (AGND) - I14-7 (GND)
    T6-8 (VC5) - Body ground
    10 kΩ or higher
    T6-11 (CODE) - Body ground
    T6-12 (TXCT) - Body ground
    T6-13 (AGND) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT TRANSPONDER KEY ECU ASSEMBLY


    B111616E10
  1. Reconnect the T6 ECU and I14 amplifier connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Voltage:
    Tester Connection
    Condition
    Specified Condition
    T6-8 (VC5) - Body ground
    No key is in ignition key cylinder
    Below 1 V
    Key is in ignition key cylinder
    4.6 to 5.4 V

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester Connection
    Condition
    Specified Condition
    T6-13 (AGND) - Body ground
    Always
    Below 1 Ω



NG
REPLACE TRANSPONDER KEY ECU ASSEMBLY
OK

REPLACE TRANSPONDER KEY AMPLIFIER