DTC B1182/19 Short to GND in Driver Side Squib 2nd Step Circuit |
| DTC No. | DTC Detecting Condition | Trouble Area |
| B1182/19 |
|
|
| 1.CHECK STEERING PAD (DRIVER SIDE SQUIB 2ND STEP) |
![]() |
Turn the ignition switch to the LOCK position.
Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
Disconnect the connectors from the steering pad.
Connect SST (resistance 2.1 Ω) to the spiral cable.
Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.
Turn the ignition switch to the ON position, and wait for at least 60 seconds.
Clear the DTCs stored in memory (Click here).
Turn the ignition switch to the LOCK position.
Turn the ignition switch to the ON position, and wait for at least 60 seconds.
Check the DTCs (Click here).
|
| ||||
| OK | ||
| ||
| 2.CHECK DRIVER SIDE SQUIB 2ND STEP CIRCUIT |
![]() |
Turn the ignition switch to the LOCK position.
Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
Disconnect SST (resistance 2.1 Ω) from the spiral cable.
Disconnect the connector from the center airbag sensor assembly.
Measure the resistance according to the value(s) in the table below.
| Tester connection | Condition | Specified condition |
| D2+ - Body ground | Always | 1 MΩ or higher |
| D2- - Body ground | Always | 1 MΩ or higher |
|
| ||||
| OK | |
| 3.CHECK CENTER AIRBAG SENSOR ASSEMBLY |
![]() |
Connect the connectors to the steering pad and the center airbag sensor assembly.
Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.
Turn the ignition switch to the ON position, and wait for at least 60 seconds.
Clear the DTCs stored in memory (Click here).
Turn the ignition switch to the LOCK position.
Turn the ignition switch to the ON position, and wait for at least 60 seconds.
Check the DTCs (Click here).
|
| ||||
| OK | ||
| ||
| 4.CHECK INSTRUMENT PANEL WIRE |
![]() |
Disconnect the instrument panel wire connector from the spiral cable.
Measure the resistance according to the value(s) in the table below.
| Tester connection | Condition | Specified condition |
| A24-4 (D2+) - Body ground | Always | 1 MΩ or higher |
| A24-3 (D2-) Body ground | Always | 1 MΩ or higher |
|
| ||||
| OK | |
| 5.CHECK SPIRAL CABLE |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester connection | Condition | Specified condition |
| D2+ - Body ground | Always | 1 MΩ or higher |
| D2- - Body ground | Always | 1 MΩ or higher |
|
| ||||
| OK | ||
| ||