Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Radio Receiver Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to the radio receiver.

WIRING DIAGRAM


E155792E02


INSPECTION PROCEDURE

1.INSPECT RADIO RECEIVER ASSEMBLY


    E155794E02
  1. Disconnect the radio receiver connectors.

  1. Measure the resistance according to the value in the table below.

    Standard resistance:
    Tester connection
    Condition
    Specified condition
    GND - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the values in the table below.

    Standard voltage:
    Tester connection
    Condition
    Specified condition
    +B - GND (*2) (*3) (*4)
    Always
    10 to 14 V
    B - GND (*1)
    Always
    10 to 14 V
    ACC - GND
    Ignition switch ACC
    10 to 14 V

    *1: 10 Speaker System
    *2: 6 Speaker with Rear Seat Entertainment System
    *3: 6 Speaker without Rear Seat Entertainment System
    *4: for "Bluetooth" handsfree Function



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE