INTUITIVE PARKING ASSIST SYSTEM > Rear Clearance Sonar Sensor LH Circuit |

| 1.INSPECT NO. 1 ULTRASONIC SENSOR |
![]() |
Remove the No. 1 ultrasonic sensor.
Measure the resistance according to the value(s) in the table below.
| Tester connection | Condition | Specified condition |
| 1 - 2 | Always | 8 to 12 kΩ |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - NO. 1 ULTRASONIC SENSOR) |
![]() |
Disconnect the C9 connector from the clearance warning ECU.
![]() |
Disconnect the U4 connector from the No. 1 ultrasonic sensor.
Measure the resistance according to the value(s) in the table below.
| Tester connection | Condition | Specified condition |
| S3 - S | Always | Below 1 Ω |
| E2 - E | Always | Below 1 Ω |
| S3 - Body ground | Always | 10 kΩ or higher |
| E2 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||