INTUITIVE PARKING ASSIST SYSTEM > OPERATION CHECK |
| DETECTION RANGE MEASUREMENT AND INDICATOR CHECK |
Turn the IG switch ON.
Move the shift lever to the R position (when the back sonar and rear clearance sonar is checked).
With front clearance sonar:
Move the shift lever to the N position (when the front clearance sonar is checked).
Turn the clearance sonar main switch ON.
Move a φ 60 mm (2.36 in.) pole around the sensor to measure the detection range of the sensor.

Check the indicator and the buzzer sounding condition when the back sonar sensor detects an obstacle.

| Ignition switch | Clearance sonar main switch | Shift position |
| ON | ON | R position |
Check the indicator and the buzzer sounding condition when the rear clearance sonar sensor detects an obstacle.

| Ignition switch | Clearance sonar main switch | Shift position |
| ON | ON | R position |
With front clearance sonar:
Check the indicator and the buzzer sounding condition when the front clearance sonar sensor detects an obstacle.

| Ignition switch | Clearance sonar main switch | Shift position | Vehicle speed |
| ON | ON | Except P position | 10 km/h (6 mph) or less |
| CHECK INITIAL CHECK FUNCTION |
![]() ![]() |
Check the initial check function for the LED and buzzer.
Turn the ignition switch and clearance main switch ON. The LED are buzzer will operate for about 1 second +- 0.3 seconds, regardless of shift lever position or vehicle speed. The system will then begin normal detection operation.
If the LED or buzzer is faulty, the relevant LED and buzzer operate as shown in the illustration below.
![]() ![]() |
Check the initial check function for the sensor.
For vehicles with 4 sensors: