Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



Data List
Using Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
  1. Warm up the engine.

  2. Turn the ignition switch off.

  3. Connect Techstream to the DLC3.

  4. Turn the ignition switch to the ON position.

  5. Turn the tester ON.

  6. Enter following menus:

    1. for Combination meter: Body Electrical / Combination Meter / Data List.

    2. for ABS/TRAC/VSC: Chassis / ABS/VSC/TRAC / Data List.

    3. for Engine and ECT: Powertrain / Engine and ECT / Data List.

    4. for Main Body: Body Electrical / Main Body / Data List.

  7. Check values by referring to the table below.

    Combination Meter: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Vehicle Speed Meter
    Vehicle speed/Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph)
    Almost same as actual vehicle speed (When driving)
    -
    Engine Rpm
    Engine speed/Min.: 0 rpm, Max.: 12,750 rpm
    Almost same as actual engine speed (When engine is running)
    -
    Fuel Input
    Fuel input signal/Min.: 0, Max. 255
    Fuel gauge indicates (F): 35
    -
    Fuel gauge indicates (3/4): 85
    -
    Fuel gauge indicates (1/2): 145
    -
    Fuel gauge indicates (1/4): 186
    -
    Fuel gauge indicates (E): 205
    -
    Rheostat Value
    Light Control Rheostat/Min.: 0, Max.: 255
    Light control rheostat switch is Dark (0) → Bright (255)
    -
    ODO/TRIP Change SW
    ODO/TRIP switch is ON/OFF
    ON: Switch is pushed
    OFF: Switch is released
    -
    Tail Cancel SW
    TAIL CANCEL switch is ON/OFF
    ON: Switch is pushed
    OFF: Switch is released
    -

    ABS/VSC/TRAC: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    FR/FL/RR/RL Wheel Speed
    Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
    Almost same as actual vehicle speed (When driving)
    -
    Vehicle Speed
    Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
    Almost same as actual vehicle speed (When driving)
    -

    Engine and ECT: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Engine Speed
    Engine speed/Min.: 0 rpm, Max.: 12,750 rpm
    Almost same as actual vehicle speed (When driving)
    -
    Coolant Temp
    Coolant temperature/Min.: -40°C (-40°F), Max.: 140°C (284°F)
    After warming up: 80 to 95°C (176 to 203°F)
    If the value is "-40°C (-40°F)" or "140°C (284°F)", sensor circuit is open or shorted.


Active Test
Using Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time.
Data List information can be displayed while performing Active Tests.
  1. Connect Techstream to the DLC3.

  2. Turn the ignition switch to the ON position.

  3. Turn the tester ON.

    1. for Combination Meter: Body Electrical / Combination Meter / Active Test.

    2. for Main Body: Body Electrical / Main Body / Active Test.

  4. Enter following menus:

    1. for Combination Meter: Body Electrical / Combination Meter / Active Test.

    2. for Main Body: Body Electrical / Main Body / Active Test.

  5. Check the operation by referring to the table below.

    Combination Meter: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Speed Meter Operation
    Speedometer
    0, 40, 80, 120 (mph) (*1)
    -
    0, 40, 80, 120, 160 (km/h) (*2)
    -
    Tacho Meter Operation
    Tachometer
    0, 1,000, 2,000, 3,000, 4,000, 5,000, 6,000, 7,000 (rpm)
    -
    Fuel Meter Operation
    Fuel receiver gauge
    OFF, EMPTY, 1/2, FULL
    -
    Water Temperature Meter Operation
    Engine coolant temperature receiver gauge
    OFF, LOW, NORMAL, HIGH
    -
    A/T Indicator Operation 1
    A/T shift indicator light
    A/T shift L, 2, 3, 4, D, N, R, P indicator light OFF/ON
    Confirm that the vehicle is stopped with the engine idling
    Indicat. Lamp Fuel
    FUEL warning light (Fuel level warning light)
    FUEL warning light OFF/ON
    Confirm that the vehicle is stopped with the engine idling
    Driver Side Seat Belt
    SEAT BELT warning light
    SEAT BELT indicator light OFF/ON
    Confirm that the vehicle is stopped with the engine idling-
    Indicat. Oil Pressure
    OIL PRESSURE warning light
    OIL PRESSURE warning light OFF/ON
    Confirm that the vehicle is stopped with the engine idling
    Indicat. Lamp Charge
    CHARGE warning light
    CHARGE warning light OFF/ON
    Confirm that the vehicle is stopped with the engine idling
    Indicat. Lamp Head (*1)
    HEAD indicator light
    HEAD indicator light OFF/ON
    Confirm that the vehicle is stopped with the engine idling
    Indicat. Lamp Tail (*2)
    TAIL indicator light
    TAIL indicator light OFF/ON
    Confirm that the vehicle is stopped with the engine idling
    Indicat. Lamp Cruise
    CRUISE indicator light
    CRUISE indicator light OFF/ON
    Confirm that the vehicle is stopped with the engine idling
    Indicat. Lamp Airbag
    SRS warning light
    SRS indicator light OFF/ON
    Confirm that the vehicle is stopped with the engine idling
    Indicat. Lamp Beam
    BEAM indicator light
    BEAM indicator light OFF/ON
    Confirm that the vehicle is stopped with the engine idling
    Indicat. Lamp TRC OFF
    TRAC OFF indicator light
    TRAC OFF indicator light OFF/ON
    Confirm that the vehicle is stopped with the engine idling
    Indicat. Lamp Slip (*3)
    SLIP indicator light
    SLIP indicator light OFF/ON
    Confirm that the vehicle is stopped with the engine idling
    Indicat. ODO/TRIP Display
    ODO/TRIP Display
    ODO/TRIP display OFF/ON
    Confirm that the vehicle is stopped with the engine idling
    Indicat. Lamp L-Cruise (*4)
    L-Cruise indicator light
    L-cruise indicator light is OFF/ON
    Confirm that the vehicle is stopped with the engine idling
    Indicat. Lamp L-Cruise Check(*4)
    L-Cruise CHECK indicator light
    L-cruise CHECK indicator light is OFF/ON
    Confirm that the vehicle is stopped with the engine idling
    LIndicat. Lamp L-Cruise Ready (*4)
    L-Cruise READY indicator light
    READY indicator light is OFF/ON
    Confirm that the vehicle is stopped with the engine idling
    Key Remained Buzzer
    Key reminder warning buzzer
    Key reminder warning buzzer is OFF/ON
    Confirm that the vehicle is stopped with the engine idling
    Seat Belt Buzzer
    Seat belt warning buzzer
    Seat belt warning buzzer is OFF/ON
    Confirm that the vehicle is stopped with the engine idling

    Main Body: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Dimmer signal (*5)
    Auto dimmer signal
    Auto dimmer signal is OFF/ON
    OFF: Auto dimmer is OFF
    ON: Auto dimmer is ON
    *1: for U.S.A.
    *2: Except for U.S.A.
    *3: with VSC
    *4: with Dynamic Laser Cruise Control System
    *5: for Optitron Meter