Home › SUSPENSION & AXLE › AXLE › FRONT AXLE HUB BOLT

FRONT AXLE HUB BOLT > REPLACEMENT

for Preparation Click here


HINT:
Replace the RH side using the same procedures as for the LH side.



1. REMOVE FRONT WHEEL


2. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY LH


    C067088
  1. Remove the 2 bolts and separate the front disc brake caliper assembly LH from the steering knuckle LH.

    NOTICE:
    Use a string or other device to keep the brake caliper from hanging down.



3. REMOVE FRONT DISC


4. REMOVE FRONT AXLE LH HUB BOLT


    D027405E02
  1. Temporarily install the 2 nuts and washers to the front axle LH hub bolt as shown in the illustration.

  1. Using SST(s) and a screwdriver or an equivalent to hold the front axle, remove the front axle LH hub bolt.

    SST
    09628-10011  



5. INSTALL FRONT AXLE LH HUB BOLT


    D027401E03
  1. Install a washer and nut to a new front axle LH hub bolt as shown in the illustration.

  1. Using a screwdriver to hold the front axle, install the hub bolt by torquing the nut.



6. INSTALL FRONT DISC


7. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY LH


    C067088
  1. Install the front disc brake caliper assembly LH with the 2 bolts to the steering knuckle LH.

    Torque:
    104 N*m{ 1,060 kgf*cm , 77 ft.*lbf }



8. INSTALL FRONT WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }