Home › SUSPENSION & AXLE › AXLE › REAR AXLE HUB BOLT

REAR AXLE HUB BOLT > REPLACEMENT

for Preparation Click here


HINT:
Replace the RH side using the same procedures as for the LH side.



1. REMOVE REAR WHEEL


2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY LH
  1. Separate rear disc brake caliper assembly LH for 2WD and disk rear brake type .



3. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY LH
  1. Separate rear disc brake caliper assembly LH for 4WD and disk rear brake type .



4. REMOVE REAR DISC
  1. Remove rear disc for disk rear brake type.



5. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY
  1. Remove rear brake drum sub-assembly for drum rear brake type.



6. REMOVE REAR AXLE LH HUB BOLT


    G026421E02
  1. Temporarily install the 2 nuts and washers to the rear axle LH hub bolt as shown in the illustration.

  1. Using SST(s) and a hammer handle or an equivalent to hold the hub & bearing assembly, remove the rear axle LH hub bolt.

    SST
    09628-10011  



7. INSTALL REAR AXLE LH HUB BOLT


    G026422E02
  1. Install a washer and nut to a new bolt, as shown in the illustration.

  1. Using a hammer handle or an equivalent to hold the hub & bearing assembly, install the rear axle LH hub bolt by tightening the nut.



8. INSTALL REAR DISC
  1. Install rear disc for disk rear brake type.



9. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH
  1. Install rear disc brake caliper assembly LH for 2WD and disk rear brake type .



10. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH
  1. Install rear disc brake caliper assembly LH for 4WD and disk rear brake type .



11. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY
  1. Install rear brake drum sub-assembly for drum rear brake type.



12. INSTALL REAR WHEEL

Torque:
103 N*m{ 1,050 kgf*cm , 76 ft.*lbf }