THROTTLE BODY > ON-VEHICLE INSPECTION |
| 1. INSPECT THROTTLE BODY |
Listen to the throttle control motor operating sounds.
Turn the ignition switch to ON.
When pressing the accelerator pedal position sensor lever, listen to the running motor. Make sure that no friction noise comes from the motor.
If friction noise exists, replace the throttle body.
Inspect the throttle position sensor.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Check that the MIL turns off.
Turn the Techstream to ON.
Enter the following menus: Powertrain / Engine and ECT / Data List / Throttle Position.
Depress the accelerator pedal. When the throttle valve is fully opened, check that the value of Throttle Position is within the specification.