Home › ENGINE › 2GR-FE ENGINE CONTROL SYSTEM › ENGINE COOLANT TEMPERATURE SENSOR

ENGINE COOLANT TEMPERATURE SENSOR > INSPECTION

for Preparation Click here



1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR


    A164436E01
  1. Using an ohmmeter, measure the resistance between the terminals.

    Standard resistance:
    Condition
    Specified Condition
    20°C (68°F)
    2.32 to 2.59 kΩ
    80°C (176°F)
    0.310 to 0.326 kΩ

    1. If the result is as specified, do not replace the engine coolant temperature sensor.
    1. If the result is not as specified, replace the engine coolant temperature sensor.

    NOTICE:
    In case of checking the engine coolant temperature sensor in water, do not allow water to go into the terminals. After checking, dry the engine coolant temperature sensor.