FRONT POWER SEAT CONTROL SYSTEM > ECU Power Source Circuit |

| 1.INSPECT POSITION CONTROL ECU AND SWITCH ASSEMBLY (POWER SEAT CONTROL SWITCH AND ECU POWER SOURCE CIRCUIT) |
![]() |
Disconnect the position control ECU and switch assembly connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| P58-5 (+B) - Body ground | Always | 10 to 14 V |
| P59-4 (IG) - Body ground | Ignition switch on | 10 to 14 V |
| P59-8 (SYSB) - Body ground | Always | 10 to 14 V |
|
| ||||
| OK | |
| 2.INSPECT POSITION CONTROL ECU AND SWITCH ASSEMBLY (POWER SEAT CONTROL SWITCH AND ECU GROUND CIRCUIT) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| P58-1 (GND) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||