FRONT POWER SEAT CONTROL SYSTEM > Driving Position Memory Switch Circuit (w/ Memory) |

| 1.READ VALUE USING TECHSTREAM |
Connect Techstream (with CAN VIM) to the DLC3.
Turn the ignition switch on.
Read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| M2 Switch | Seat memory M2 switch signal/ ON or OFF | ON: Seat memory M2 switch is ON OFF: Seat memory M2 switch is OFF | - |
| M1 Switch | Seat memory M1 switch signal/ ON or OFF | ON: Seat memory M1 switch is ON OFF: Seat memory M1 switch is OFF | - |
| SET Switch | Seat memory set switch signal/ ON or OFF | ON: Seat memory set switch is ON OFF: Seat memory set switch is OFF | - |
|
| ||||
| OK | ||
| ||
| 2.INSPECT SEAT MEMORY SWITCH (DRIVING POSITION MEMORY SWITCH) |
Remove the seat memory switch.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Position | Specified Condition |
| 1 (E) - 2 (MMRY) | SET switch ON (pushed) | Below 1 Ω |
| 1 (E) - 2 (MMRY) | SET switch OFF (not pushed) | 10 kΩ or higher |
| 1 (E) - 4 (1) | SW1 switch ON (pushed) | Below 1 Ω |
| 1 (E) - 4 (1) | SW1 switch OFF (not pushed) | 10 kΩ or higher |
| 1 (E) - 3 (2) | SW2 switch ON (pushed) | Below 1 Ω |
| 1 (E) - 3 (2) | SW2 switch OFF (not pushed) | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (SEAT MEMORY SWITCH CIRCUIT) |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Position | Specified Condition |
| S33-2 (MMRY) - S33-1 (E) | Ignition switch on | 10 to 14 V |
| S33-3 (2) - S33-1 (E) | Ignition switch on | 10 to 14 V |
| S33-4 (1) - S33-1 (E) | Ignition switch on | 10 to 14 V |
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (OUTER MIRROR CONTROL ECU LH - SEAT MEMORY SWITCH) |
![]() |
Disconnect outer mirror control ECU LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Position | Specified Condition |
| S33-1 (E) - Body ground | Always | Below 1 Ω |
| S33-2 (MMRY) - O9-25 (MM) | Always | Below 1 Ω |
| S33-3 (2) - O9-23 (M2) | Always | Below 1 Ω |
| S33-4 (1) - O9-22 (M1) | Always | Below 1 Ω |
| S33-2 (MMRY) - Body ground | Always | 10 kΩ or higher |
| S33-3 (2) - Body ground | Always | 10 kΩ or higher |
| S33-4 (1) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||