Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > ECU Power Source Circuit


DESCRIPTION

This circuit provides power to operate the theft deterrent (warning) ECU.

WIRING DIAGRAM


B109004E07


INSPECTION PROCEDURE

1.INSPECT FUSE (ECU-B)
  1. Remove the ECU-B fuse from the engine room J/B.

  1. Measure the resistance.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2.CHECK INSTRUMENT PANEL J/B ASSEMBLY (POWER SOURCE)


    B067854E02
  1. Disconnect the 1C J/B connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Symbol (Tester Connection)
    Specified Condition
    BECU (1C-24) - Body ground
    10 to 14 V



OK
REPAIR OR REPLACE HARNESS OR CONNECTOR
NG


3.CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL J/B ASSEMBLY - BODY GROUND)


    B068353E03
  1. Disconnect the 1K and 1L J/B connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Symbol (Tester Connection)
    Specified Condition
    GND1 (1L-16) - Body ground
    Below 1 Ω
    GND2 (1K-17) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE INSTRUMENT PANEL J/B ASSEMBLY