Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Ignition Switch Circuit


DESCRIPTION

When the ignition switch is turned to the ON position, battery positive voltage is applied to terminal IG of the ECU. When battery positive voltage is applied to terminal IG of the ECU while the theft deterrent system is operating, the warning stops.

WIRING DIAGRAM


B109005E02


INSPECTION PROCEDURE

1.INSPECT FUSES (ECU-IG, AM1)
  1. Remove the ECU-IG and AM1 fuses from the instrument panel J/B.

  1. Measure the resistance.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSES
OK


2.INSPECT RELAY (IG1)


    B068834E03
  1. Remove the IG1 relay from the instrument panel J/B.

  1. Check the operation of the IG1 relay.

    Standard resistance:
    Terminal No.
    Specified Condition
    3 - 5
    10 kΩ or higher
    3 - 5
    Below 1 Ω
    (When battery voltage is applied to terminals 1 and 2)



NG
REPLACE RELAY
OK


3.INSPECT IGNITION OR STARTER SWITCH ASSEMBLY
  1. Disconnect the I15 switch connector.



    B067054E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Position
    Specified Condition
    1 - 3
    ACC
    Below 1 Ω
    1 - 2
    ON
    1 - 3
    5 - 6
    1 - 2
    START
    5 - 4
    5 - 6



NG
REPLACE IGNITION OR STARTER SWITCH ASSEMBLY
OK


4.CHECK INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (POWER SOURCE)


    B109163E03
  1. Disconnect the 1A J/B connector.

  1. Turn the ignition switch ON.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Specified Condition
    1A-1 - Body ground
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE INSTRUMENT PANEL J/B ASSEMBLY