Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Engine Hood Courtesy Switch Circuit


DESCRIPTION

The engine hood courtesy switch is built in the engine hood lock assembly. The switch turns on when the engine hood is opened and turns off when the engine hood is closed.

WIRING DIAGRAM


B110535E02


INSPECTION PROCEDURE

1.INSPECT ENGINE HOOD COURTESY SWITCH


    B067860E02
  1. Remove the courtesy switch.

  1. Disconnect the E3 switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1-2
    Pushed:
    OFF (Locked)
    10 kΩ or higher
    1-2
    Free:
    ON (Unlocked)
    Below 1 Ω



NG
REPLACE ENGINE HOOD COURTESY SWITCH
OK


2.CHECK HARNESS AND CONNECTOR (MULTIPLEX NETWORK BODY ECU - ENGINE HOOD COURTESY SWITCH)


    B068354E02
  1. Disconnect the B8 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Symbol (Tester Connection)
    Specified Condition
    HCTY (B8-10) - (E3-1)
    Below 1 Ω
    HCTY (B8-10) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (ENGINE HOOD COURTESY SWITCH - BODY GROUND)


    B067849E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    E3-2 - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MULTIPLEX NETWORK BODY ECU