Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Security Horn Circuit


DESCRIPTION

During the alarm sounding state, the relay in the ECU turns on and off in a cycle of approximately 0.2 seconds, causing the security horn to sound.

WIRING DIAGRAM


B109007E02


INSPECTION PROCEDURE

1.INSPECT SECURITY HORN ASSEMBLY


    B070004
  1. Disconnect the T1 security horn connector.

  1. Check the operation of the security horn.

    Standard:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 1
    Battery negative (-) → Horn body
    Security horn sounds



NG
REPLACE SECURITY HORN ASSEMBLY
OK


2.CHECK HARNESS AND CONNECTOR (MULTIPLEX NETWORK BODY ECU - SECURITY HORN ASSEMBLY)


    B068016E05
  1. Disconnect the B8 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Symbol (Tester Connection)
    Specified Condition
    SH (B8-1) - (T1-1)
    Below 1 Ω
    SH (B8-1) or (T1-1) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MULTIPLEX NETWORK BODY ECU