Home › BODY ELECTRICAL › DOOR LOCK › REAR DOOR LOCK

REAR DOOR LOCK > INSPECTION

for Preparation Click here



1. INSPECT REAR DOOR LOCK ACTUATOR ASSEMBLY LH


    B068457E01
  1. Apply battery voltage to the door lock and check operation of the motor.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 2
    Battery negative (-) → Terminal 3
    Lock
    Battery positive (+) → Terminal 3
    Battery negative (-) → Terminal 2
    Unlock

    HINT:
    If the result is not as specified, replace the door lock assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Door Lock Position
    Specified Condition
    1 - 4
    Lock
    10 kΩ or higher
    1 - 4
    Unlock
    Below 1 Ω

    HINT:
    If the result is not as specified, replace the door lock assembly.



2. INSPECT REAR DOOR LOCK ACTUATOR ASSEMBLY RH


    B067752E01
  1. Apply battery voltage to the door lock and check operation of the motor.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 2
    Battery negative (-) → Terminal 3
    Lock
    Battery positive (+) → Terminal 3
    Battery negative (-) → Terminal 2
    Unlock

    HINT:
    If the result is not as specified, replace the door lock assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Door Lock Position
    Specified Condition
    1 - 4
    Lock
    10 kΩ or higher
    1 - 4
    Unlock
    Below 1 Ω

    HINT:
    If the result is not as specified, replace the door lock assembly.