Home › BODY ELECTRICAL › DOOR LOCK › FRONT DOOR LOCK

FRONT DOOR LOCK > INSPECTION

for Preparation Click here



1. INSPECT FRONT DOOR W/ MOTOR LOCK ASSEMBLY LH


    B065427E04
  1. Apply battery voltage to the door lock and check operation of the motor.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 4
    Battery negative (-) → terminal 1
    Lock
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 4
    Unlock

    HINT:
    If the result is not as specified, replace the door lock assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Door Lock Position
    Specified Condition
    7 - 8
    Lock
    10 kΩ or higher
    7 - 8
    Unlock
    Below 1 Ω

    HINT:
    If the result is not as specified, replace the door lock assembly.



    B065428E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    7 - 9
    ON (Door lock set to LOCK)
    Below 1 Ω
    7 - 9, 7 - 10
    OFF (Free)
    -
    7 - 10
    ON (Door lock set to UNLOCK)
    Below 1 Ω

    HINT:
    If the result is not as specified, replace the door lock assembly.



2. INSPECT FRONT DOOR LOCK W/ MOTOR ASSEMBLY RH


    B065429E03
  1. Apply battery voltage to the door lock and check operation of the motor.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 4
    Battery negative (-) → Terminal 1
    Lock
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 4
    Unlock

    HINT:
    If the result is not as specified, replace the door lock assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Door Lock Position
    Specified Condition
    7 - 8
    Lock
    10 kΩ or higher
    7 - 8
    Unlock
    Below 1 Ω

    HINT:
    If the result is not as specified, replace the door lock assembly.



    B065430E16
  1. Inspect the resistance of the door lock and unlock switch.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    6 - 8
    ON (Door lock set to LOCK)
    Below 1 Ω
    5 - 8, 6 - 8
    OFF (Free)
    -
    5 - 8
    ON (Door lock set to UNLOCK)
    Below 1 Ω

    HINT:
    If the result is not as specified, replace the door lock assembly.