Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM

REAR VIEW MONITOR SYSTEM > TERMINALS OF ECU

for Preparation Click here



TELEVISION CAMERA ASSEMBLY


  1. Disconnect the T10 camera connector.


    I035060E21

  2. Measure the voltage and resistance of each terminal of the wire harness side connector.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified value
    CGND (T10-3) - Body ground
    W - Body ground
    Ground
    Always
    Below 1 Ω
    CB+ (T10-4) - CGND (T10-3)
    R - W
    Power source
    Ignition switch ON, shift lever R position
    Approx. 6 V
    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the T10 camera connector.

  4. Measure the voltage and frequency of each terminal of the connector.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified value
    CV+ (T10-2) - CV- (T10-1)
    B - Shielded
    Display signal
    Ignition switch ON, shift lever R position
    See waveform 1
    If the result is not as specified, the camera may have a malfunction.



  5. E119731E01
  6. Reference:
    Oscilloscope waveform

    1. Waveform 1
      Item
      Content
      Measure terminal
      CV+ - CV-
      Measure set
      0.2 V/DIV., 0.2 μS/DIV.
      Condition
      Ignition switch: ON, Shift lever: R position


NAVIGATION RECEIVER ASSEMBLY (Click here)