Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Driver Side Seat Belt Warning Light does not Operate

for Preparation Click here


DESCRIPTION

When turning the ignition switch to the ON position, the combination meter assembly communicates with the supplemental restraint system by the multiplex communication system. Unless the driver side seat belt is fastened, the combination meter assembly will turn on the seat belt warning light for driver side. If the driver side seat belt is fastened, then the combination meter assembly will turn off the driver side seat belt warning light.

WIRING DIAGRAM


E159311E01


INSPECTION PROCEDURE

1.CHECK MULTIPLEX COMMUNICATION SYSTEM
  1. Check if the MULTIPLEX communication DTC is output (Click here).

    Result:

    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



NG
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS
OK


2.PERFORM ACTIVE TEST USING TECHSTREAM
  1. Connect Techstream to the DLC3.

  1. Turn the ignition switch to the ON position.

  1. Enter the following menus: Body Electrical / Main Body / Active Test.

  1. Check the operation by referring to the value(s) in the table below.

    Combination Meter: 
    Tester Display
    Test Part
    Test Details
    Diagnostic Note
    D-BELT REMIND
    SEAT BELT warning light (Driver side seat belt warning light)
    SEAT BELT indicator light OFF/ON
    -

    OK:
    Warning light condition (ON/OFF) can be switched by "ACTIVE TEST".



NG
REPLACE COMBINATION METER ASSEMBLY
OK


3.CHECK DTC
  1. Check if DTC B0126 is output (Click here).

    Result:

    Result
    Proceed to
    B0126 is not output
    A
    B0126 is output
    B



B
GO TO AIRBAG SYSTEM
A

REPLACE CENTER AIR BAG SENSOR ASSEMBLY