Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › AIRBAG SYSTEM

AIRBAG SYSTEM > Diagnosis Circuit

for Preparation Click here


DESCRIPTION

DTC output mode is set by connecting terminals TC and CG of the DLC3.
DTCs are displayed by blinking the SRS warning light.

HINT:
  1. When each warning light stays blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU is suspected.
  2. A DTC output mode signal is transmitted through BEAN and CAN to each ECU including the center airbag sensor assembly. Thus when all systems do not enter DTC output mode, there may be an ECM malfunction.


WIRING DIAGRAM


C157643E01


C157644E02


INSPECTION PROCEDURE

1.CHECK MULTIPLEX COMMUNICATION SYSTEM
  1. Check if the multiplex communication system DTC is output (Click here).

    HINT:
    The center airbag sensor assembly of this system is connected to the multiplex communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the multiplex communication system.

    OK:
    The Multiplex communication system DTC is not output.



NG
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS
OK


2.CHECK CAN COMMUNICATION SYSTEM
  1. Use the Techstream to check if the CAN communication system is functioning normally (Click here).

    HINT:
    The ECM is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.

    OK:
    The CAN communication system is functioning normally.



NG
REPAIR CAN COMMUNICATION CIRCUIT
OK


3.CHECK WIRE HARNESS (TC OF DLC3 - TC OF ECM)


    E127022E04
  1. Turn the ignition switch to the LOCK position.

  1. Disconnect the connector from the ECM.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Condition
    Specified condition
    D1-13 (TC) - E4-23 (TC)
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE WIRE HARNESS (TC OF DLC3 - TC OF ECM)
OK


4.CHECK WIRE HARNESS (CG OF DLC3 - BODY GROUND)


    C128572E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Condition
    Specified condition
    D1-4 (CG) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE WIRE HARNESS (CG OF DLC3 - BODY GROUND)
OK


5.CHECK WIRE HARNESS (TC OF DLC3 - BODY GROUND)


    C126742E16
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    Condition
    Specified condition
    D1-13 (TC) - Body ground
    Always
    1 MΩ or higher



NG
REPAIR OR REPLACE WIRE HARNESS OR EACH ECU
OK

REPLACE CENTER AIRBAG SENSOR ASSEMBLY