Home › ENGINE › 2GR-FE FUEL › FUEL SENDER GAUGE ASSEMBLY

FUEL SENDER GAUGE ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT FUEL SENDER GAUGE ASSEMBLY


    E143790E02
  1. Disconnect the connector from the fuel sender gauge.

  1. Check that the float moves smoothly between F and E.

  1. Measure the resistance between terminals 1 and 2 of the connector according to the value(s) in the table below.

    Standard resistance: Fuel sender gauge:
    Float Level
    Resistance (Ω)
    F
    13.5 to 16.5
    Between E and F
    13.5 to 414.5 (Gradually changes)
    E
    405.5 to 414.5

    HINT:
    If the value is not as specified, replace the fuel sender gauge assembly.