Home › BODY ELECTRICAL › AUDIO / VISUAL › LUGGAGE SPEAKER

LUGGAGE SPEAKER > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT REAR SPEAKER

HINT:
Remove interior parts so that the rear speaker can be seen.

  1. Check the speaker installation.

    OK:
    The speaker is securely installed.

    If the result is not as specified, reinstall the rear speaker.

  1. Visually check the speaker.

    OK:
    The cone paper of the speaker is not torn.

    If the result is not as specified, replace the rear speaker.

  1. Speaker resistance check

    1. Disconnect the rear speaker connector.

    2. Measure the resistance between the terminals of the speaker.

      Standard resistance:
      6 Speaker system:
      Approximately 4 Ω
      10 Speaker system:
      Approximately 2.4 Ω

      If the result is not as specified, replace the rear speaker.



2. INSPECT REAR STEREO COMPONENT SPEAKER

HINT:
Remove interior parts so that the rear stereo component speaker can be seen.

  1. Check the speaker installation.

    OK:
    The speaker is securely installed.

    If the result is not as specified, reinstall the rear stereo component speaker.

  1. Visually check the speaker.

    OK:
    The cone paper of the speaker is not torn.

    If the result is not as specified, replace the rear stereo component speaker.



3. INSPECT WOOFER BOX SPEAKER ASSEMBLY

HINT:
Remove interior parts so that the woofer box speaker assembly can be seen.

  1. Check the speaker installation.

    OK:
    The speaker is securely installed.

    If the result is not as specified, reinstall the woofer box speaker assembly.

  1. Visually check the speaker.

    OK:
    The cone paper of the speaker is not torn.

    If the result is not as specified, replace the woofer box speaker assembly.



  1. Speaker resistance check



      E120044
    1. Disconnect the woofer box speaker assembly connector.

    2. Measure the resistance between the terminals of the speaker.

      NOTICE:
      The speaker should not be removed for checking.

      Standard resistance:
      Tester connection
      Condition
      Specified condition
      1 - 3
      Always
      Approximately 1.2 Ω
      2 - 4
      Always
      Approximately 1.2 Ω

      If the result is not as specified, replace the woofer box speaker assembly.