DTC P0717 Turbine Speed Sensor Circuit No Signal |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0717 | ECM detects conditions (a), (b) and (c) continuously for 5 sec. or more: (1-trip detection logic) (a) Vehicle speed: 50 km/h (31 mph) or more (b) Park/neutral position switch (NSW (STAR) and R) is OFF (c) Speed sensor (NT): less than 300 rpm |
|

| Terminal | NT+ - NT- |
| Tool setting | 5 V/DIV., 0.5 ms./DIV. |
| Vehicle condition | Vehicle speed 20 km/h (12 mph) |
| Related DTCs | P0717: Speed sensor (NT)/Verify pulse input |
| Required sensors/Components | Speed sensor (NT), Speed sensor (NC) |
| Frequency of operation | Continuous |
| Duration | 5 sec. |
| MIL operation | Immediate |
| Sequence of operation | None |
| The monitor will run whenever this DTC is not present. | P0500 (VSS) P0748, P0778, P0798 (Shift solenoid valve (range)) |
| Shift change | Shift change is completed and before starting next shift change operation |
| ECM selected gear | 2nd, 3rd, 4th and 5th |
| Output shaft rpm | 1,000 rpm or more |
| NSW (STAR) switch | OFF |
| R switch | OFF |
| L switch | OFF |
| Engine | Running |
| Ignition switch | ON |
| Starter | OFF |
| Sensor signal rpm | Less than 300 rpm |
| Speed sensor (NT) | Turbine speed is equal to engine speed with lock-up ON |

| 1.INSPECT SPEED SENSOR INSTALLATION |
![]() |
Check the speed sensor installation.
|
| ||||
| OK | |
| 2.INSPECT SPEED SENSOR (NT) |
![]() |
Disconnect the speed sensor connector from the transaxle.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition 20 °C (68 °F) |
| 1 - 2 | 560 to 680 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (SPEED SENSOR - ECM) |
![]() |
Connect the speed sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition 20°C (68°F) |
| E10-35 (NT+) - E10-27 (NT-) | 560 to 680 Ω |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| E10-35 (NT+) - Body ground | 10 kΩ or higher |
| E10-27 (NT-) - Body ground |
|
| ||||
| OK | ||
| ||