Home › TRANSMISSION ยท U151F AUTOMATIC TRANSAXLE › TRANSMISSION WIRE

TRANSMISSION WIRE > INSTALLATION

for Preparation Click here



1. INSTALL TRANSMISSION WIRE


    D030867
  1. Coat the O-ring of the transmission wire connector with ATF and install it.



    D030866
  1. Install the transmission wire with the bolt.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 ft.*lbf }



2. CONNECT TRANSMISSION WIRE


    C091927E04
  1. Coat the O-ring of the ATF temperature sensor with ATF.

  1. Install the ATF temperature sensor with the lock plate and bolt.

    Torque:
    6.6 N*m{ 67 kgf*cm , 58 ft.*lbf }

  1. Connect the 7 shift solenoid valve connectors.



3. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY


    D030865
  1. Install the 2 magnets in the oil pan.

  1. Apply seal packing to the 18 bolts.

    Seal packing:
    THREE BOND 2430 or equivalent



    C091925
  1. Using a new gasket, install the oil pan to the transaxle case with the 18 bolts.

    Torque:
    7.8 N*m{ 80 kgf*cm , 69 in.*lbf }

    NOTICE:
    Apply seal packing to the bolts and tighten them within 10 minutes of application.



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


5. ADD AUTOMATIC TRANSAXLE FLUID


6. INSPECT AUTOMATIC TRANSAXLE FLUID

HINT:
Drive the vehicle so that the engine and transaxle are at normal operating temperature.

Fluid temperature:
70 to 80°C (158 to 176°F)

  1. Park the vehicle on a level surface and set the parking brake.



    D025120E05
  1. With the engine idling and the brake pedal depressed, move the shift lever to all positions from P to L and return to the P position.

  1. Take out the dipstick and wipe it clean.

  1. Put the dipstick back all the way.

  1. Take out the dipstick again and check that the fluid level is within the HOT range.
    If the fluid level is below the HOT range, add new fluid and recheck the fluid level.
    If the fluid level exceeds the HOT range, drain the fluid once, add the proper amount of new fluid and recheck the fluid level.
    If there are leaks, it is necessary to repair or replace O-rings, FIPGs, oil seals, plugs and/or other parts.



7. INSTALL ENGINE UNDER COVER NO.1


8. RESET MEMORY

HINT:
(Click here)